Residential PE provides PE stamped engineering drawings for permit submissions across Alabama. Your drawings are sealed and signed by a Professional Engineer holding an active license in Alabama, designed to the code edition and load criteria your building department actually enforces, at one fixed fee quoted before any work starts, typically back in 48 to 72 hours.
Code and design criteria in Alabama
Alabama applies statewide codes to commercial and state-owned construction, while residential code adoption is left to cities and counties, so the IRC edition enforced on your project depends on your jurisdiction.
Gulf Coast counties carry high design wind speeds and wind-borne debris requirements, while inland counties are governed mainly by gravity loads and shallow frost depths. We print the governing code edition and the design criteria on the sheet, so the plan reviewer can verify them without picking up the phone.
Engineering services available in Alabama
- Review and PE stamp of drawings you already have
- Structural engineering: beams, framing, foundations and lateral design
- MEP engineering: mechanical, electrical and plumbing sheets with calculations
- Civil engineering: grading, drainage and stormwater design
- Site and plot plans checked against your zoning setbacks and coverage limits
- Retaining wall design with stability calculations
- Load bearing wall removal: beam, post and footing design
Where we work in Alabama
We prepare submissions for jurisdictions throughout Alabama, including Birmingham, Montgomery, Mobile and Huntsville, and the surrounding counties. Because the service is delivered entirely online, your location inside the state changes neither the price nor the schedule, only the local code and submission requirements change, and those we look up for your address before quoting.
What your Alabama submission package includes
- Sealed, signed and dated drawings with the engineer’s Alabama license number shown
- Calculations where your jurisdiction requires them or the design needs them
- Design criteria and code notes printed on the sheets
- A print-ready PDF sized for your permit portal or the counter
- Plan review responses and revisions at no extra cost until the permit is approved
Typical Alabama projects
Decks, porches and patio covers. Interior remodels, wall removals and new openings. Garage conversions, ADUs and basement finishes. Additions and second storeys. Foundation and settlement repairs. Roof framing changes, solar mounting and re-roofs. Retaining walls, sheds, garages and pool structures. Site plans for fences, driveways and accessory buildings.
Questions about Alabama permits
Is your engineer licensed in Alabama?
Yes. Work in Alabama is sealed by a Professional Engineer holding an active Alabama license, with the number printed on the sheet so your building department can verify it.
Does my Alabama permit actually need an engineer’s stamp?
It depends on the jurisdiction and the scope. Send the address and a description of the work and we will tell you plainly, free, whether a seal is required, and if a short engineer’s letter would satisfy the reviewer instead of a full design, we will tell you that too.
How fast can I get stamped drawings in Alabama?
Standard residential scopes are typically delivered in 48 to 72 hours from the point we have the information we need. Larger packages get a firm delivery date in the quote.
What if the Alabama reviewer rejects the drawings?
We answer the comments and revise the drawings at no extra charge. Permit support is included until your submission is approved.
Next step
Send your drawings, survey, photos or sketch through the quote form, or call (737) 409-9610. A licensed engineer replies with scope, a fixed price and a delivery date, usually within the hour. Building somewhere else? See engineering services by state.